FSE SAFE Portable Fumes and Smoke Exhauster-Blower

This Fume Exhauster-Blower is designed for continuous operation. With the hose on the inlet, fumes and smoke are drawn away from the operator at welding, soldering, brazing and etching operations. Switch the same hose to the discharge to supply fresh air for workers inside tanks, manholes and other confined areas. One Fume Exhauster-Blower does the job of two fans.

Exhuasting contaminated air

If you will be using this blower to exhaust contaminated air from an operation such as welding, the fumes collected should be piped to the outside. Locate the unit as close as possible to both the operation and the outside of the building. The airflow will be reduced about 5-15 CFM for every additional foot of hose or duct installed, not including the 10 foot section of hose supplied with unit. Each 90° change in air flow direction (as with an elbow) will reduce the airflow approximately 15-20 CFM.

Supplying fresh air

Supplying fresh air to workers can be a simple operation or a very complex problem. If the worker is in a room, the required fresh air supply is generally an easy calculation. If the worker will be in an underground tank or manhole, the fresh air requirements can be a very complex problem. If there are caustic, flammable, or explosive chemicals, materials and/or air saturations present, that makes the problem that more difficult.

FEATURES:

  • AMCA Type B spark resistant construction standard for all models.
  • Totally Enclosed Fan Cooled (TEFC) motors are standard.
  • Motors are continuous duty, full horsepower rated. NOT duty rated.
  • Heavy-duty 14 gauge steel blower housing on all Type 1 models.
  • All models available with 115/230 Volt, 1 Phase, 60 Cycle or 230/460 Volt, 3 Phase, 60 Cycle motors. 575 Volt and 50 Cycle motors also available.
  • Single Phase, TEFC motors (up to 1 HP) come with an 8 foot cord, 3 prong grounded plug and a switch pre-wired for 115 Volt, 60 Cycle.
  • Inlet and discharge guards, required by OSHA, are standard.
  • Safe, no exposed moving parts.